Dragino SE01-LS LoRaWAN soil sensor for moisture, temperature and conductivity (868 MHz) — solar

SKU:3JQE
Cod. produttore:SE01-LS
Marca:Dragino
Categorie:
Disponibilità CH:
non in magazzino0
Da magazzino esterno:
Tempo di consegnain ca. 20 giorni
Il termine vale a partire da 10 pezzi. Per quantità inferiori chiedeteci. (?)

CHF144.10 IVA escl.

più spese di spedizione

LoRaWAN soil sensor measuring water content, soil temperature and electrical conductivity. Conductivity reveals the salt and nutrient content of the soil solution — only together with water content does the decisive question emerge: can the plant actually take that water up? ±3 % up to 53 % V/V, 0…20,000 µS/cm, IP66, a solar panel with a rechargeable 3000 mAh Li-ion cell.

! Per utilizzare questo dispositivo serve una rete LoRaWAN. Potete crearla voi stessi con un gateway LoRaWAN, usare la rete LORIOT o TTN, oppure la rete Swisscom LoRaWAN che copre tutta la Svizzera. Tutte queste reti sono acquistabili da noi.
 Aggiungi al confronto

The Dragino SE01-LS measures three quantities in the soil at once: water content, temperature and electrical conductivity. The third is the reason to choose this device over a plain moisture probe — it shows the salt and nutrient content of the soil solution and therefore whether a plant can take up the water that is there. High water content together with high conductivity means drought stress despite damp earth, and a moisture probe alone does not show that. This is the solar-powered version: a panel charges a rechargeable 3000 mAh Li-ion cell, and the battery change disappears as long as enough light arrives.

  • 3 quantitiesmoisture, temperature, conductivity
  • ±3 %water content up to 53 % V/V
  • 0 … 20,000 µS/cmconductivity
  • ±0.3 °Csoil temperature, −10 … 50 °C
  • IP66enclosure

What defines the SE01-LS

  • Conductivity is what makes the moisture reading meaningful: water alone does not say whether the plant can take it up. When conductivity rises — through fertilising, salt ingress or evaporation — water is drawn osmotically away from the root zone. Only both values together show the real state.
  • The moisture measurement is temperature- and conductivity-compensated: the FDR method responds to both disturbances. Dragino takes them out, and that is exactly what distinguishes a soil sensor from a cheap resistive probe whose reading wanders with salinity.
  • Temperature via an RTD element: better than 0.3 °C between −10 and 50 °C, which is precisely where soil biology and germination happen. Beyond that it stays under 0.6 °C.
  • Resolution far below the tolerance: 0.01 V/V % for water content, 0.01 °C for temperature, 1 µS/cm for conductivity. For absolute statements the tolerance applies — for changes at the same site the resolution does, and that is the more relevant figure for irrigation control.
  • The conductivity range reaches into saline soil: 20,000 µS/cm also covers substrate culture and salt-affected sites, where horticultural probes have long since run out of scale.
  • Device above, probe below: the electronics stay accessible, only the probe goes into the ground. A battery change therefore means no digging.
  • IP66 and −40 to 85 °C: built for year-round outdoor service, not merely permitted for it.
  • No battery change planned in: the solar panel charges a rechargeable 3000 mAh Li-ion cell. With sufficient light the replacement cycle disappears — at hard-to-reach measuring points the larger item over the service life. The cell is a buffer, not the main store: it carries the device overnight and through spells of bad weather.
  • Not tied to a platform: LoRaWAN 1.0.3, Class A, OTAA. Runs on TTN, ChirpStack and Swisscom LPN with the same profile.
  • Configuration over the air: reporting interval and thresholds arrive by downlink from the network server. A buried sensor stays where it is.

Where the SE01-LS is used

  • Irrigation control in field crops: watering follows the water content of the root zone rather than the calendar — the application that pays for itself fastest.
  • Greenhouse and substrate culture: here conductivity is the governing variable: it shows the substrate salting up long before the plant shows symptoms.
  • Orchards and viticulture: controlled drought stress is a quality tool — it can only be managed if the water content of the rooting horizon is known.
  • Sports turf and golf courses: even moisture across the area, with conductivity as an indication of fertiliser movement.
  • Urban trees: street trees suffer from de-icing salt; conductivity in the root zone makes that measurable rather than suspected.
  • Slope monitoring and soil mechanics: water content as an input for assessing the risk of slippage.
  • Trials and evidence keeping: three quantities with a time series at a defined depth, traceable over years.
  • Large rollouts: one device type, one mounting method, one decoder — and through the solar, NB-IoT and LTE-M versions also for sites without radio infrastructure of their own.
No light, no solar operation. A LoRaWAN uplink costs little energy, so the balance is relaxed — but it stands or falls with where the panel sits. In the shade of a hedge, behind a roof edge or down a shaft it does not carry. Where the light is missing, the battery version SE01-LB is the right choice. Calibration depends on the soil type — and Dragino does not agree with itself here. The feature list states a factory calibration for mineral soils, while the FAQ on the same page speaks of saline-alkali and loamy soil. Both stand side by side without being reconciled. In practice that means: on a different soil — peat, high humus content, very sandy — the absolute values are not usable without recalibration. Dragino supplies a formula for that, applied on the platform. For trends this is immaterial, for absolute values it is not. Anyone who only wants to know whether it is drying out can start straight away. Anyone wanting to report litres per square metre or control against a limit calibrates first. Installation matters as much. An air gap beside the probe distorts the reading more than any tolerance in the datasheet — the soil has to sit tight against it. And three quantities cost current. The five years apply to a restrained reporting interval; anyone measuring every quarter hour calculates differently.

That covers the purchase decision. What follows is the depth needed for installation, analysis and operation.

What FDR measures — and what follows from it

The method is called Frequency Domain Reflectometry. What is measured is not water but the dielectric constant of the soil. Water has about 80 of it, air 1, mineral soil constituents between 3 and 7 — water content therefore dominates the signal to such a degree that it can be inferred reliably. That is the method’s strength and at the same time the reason for its quirks.

First, the relationship depends on the soil type. The same dielectric constant means a different water content in peat than in sand, because the solid matrix differs. Hence the factory calibration to one soil type and the formula for deviating soils. Second, salt interferes. Dissolved ions raise the apparent permittivity; without compensation a fertilised soil would appear wetter than it is. That is exactly why this device measures conductivity anyway and takes it out. Third, the probe only measures its immediate surroundings — a few centimetres around the rods. A cavity beside it therefore weighs heavily.

Assessment from field practice, not a manufacturer statement: the commonest installation error is drilling too large a hole and backfilling it loosely. The probe then sits in loosened soil that holds water differently from the undisturbed ground right next to it — the series is consistent with itself, but it describes the hole and not the field. Better is a slit into which the probe’s three tines are pressed, followed by firm hand compaction of the soil. The probe sits at the end of a cable several metres long, so the device can be mounted well away from it — Dragino does not state the exact cable length, however. Anyone comparing across several sites should also record the installation depth; ten centimetres of difference shifts the curve more than any device tolerance.

Reading conductivity correctly

What is measured is the conductivity of the soil as a whole — solids, water and air together. That is not the same as the conductivity of the soil solution, which is what matters agronomically, and the two are linked through water content: the same salinity in the water gives a lower overall figure in dry soil, because there is less conducting liquid.

Consequence for analysis: conductivity rising while water content falls is the normal case during drying out and not an alarm. It becomes interesting when conductivity rises while water content stays level or increases — then salt is being added, from fertiliser, de-icing salt or saline irrigation water. The rule is therefore never to look at the two curves separately, but overlaid.

Solar operation — what carries the balance and what tips it

A LoRaWAN uplink costs little energy: the radio is awake for fractions of a second and then sleeps on at a few microamps. That makes the solar balance here considerably more relaxed than on a cellular device — the daily demand is low enough that even an overcast winter day usually still covers it. The rechargeable 3000 mAh Li-ion cell is not meant as the main store but as a buffer overnight and through spells of bad weather.

Consequence for planning: what decides is not the cell capacity but where the panel sits. Facing south and unshaded all day, the balance carries; in the shade of a hedge, behind a roof edge or down a shaft it does not — and that shows in December, not in June.

Assessment from field practice, not a manufacturer statement: for the solar version Dragino gives neither a battery life nor a minimum irradiation. With two independent variables — location and reporting interval — that is consistent, but it does not help with planning. What is usable is the cell voltage carried in every message: anyone recording it through the first winter knows afterwards whether the site carries, instead of guessing.

Data at a glance

Water content0 … 100.00 V/V % · resolution 0.01 · ±3 % up to 53 %, ±5 % above · FDR with temperature and conductivity compensation
Soil temperature−40.00 … 85.00 °C · resolution 0.01 °C · better than 0.3 °C from −10 to 50 °C, otherwise better than 0.6 °C · RTD
Conductivity0 … 20,000 µS/cm at 25 °C · resolution 1 µS/cm · 2 % of full scale · temperature compensated
RadioLoRaWAN 1.0.3, Class A, OTAA · EU868
Powersolar panel with rechargeable 3000 mAh Li-ion cell · no battery-life figure from the manufacturer
EnclosureIP66 · 195 × 125 × 55 mm · 420 g · operating temperature −40 … 85 °C
VersionsSE01-LS battery · SE01-LS solar · SE01-NB NB-IoT · SE01-CB LTE-M and NB-IoT

What the manufacturer does not state: probe material, probe length and cable length do not appear on the product page. For planning the installation those are exactly the figures needed — to be added at the first goods receipt or asked of the manufacturer.

About the predecessor: we have carried the Dragino LSE01 since 2026, which measures the same three quantities. It no longer appears in Dragino’s current reseller price list; the SE01 is its successor and measures moisture and conductivity more tightly. Existing LSE01 installations are unaffected — the payload is not the same, so swapping one in the field requires a change in the decoder.

+ Mostra altro

Dokumente

Recensioni

Ancora non ci sono recensioni.

Recensisci per primo “Dragino SE01-LS LoRaWAN soil sensor for moisture, temperature and conductivity (868 MHz) — solar”

Details

Generale
Marca
Dragino
Codice produttore
SE01-LS
Interfaccia
LoRa 868MHz
Version des LoRa (Long Range) Low-Power-Wireless-Chipsatzes, der auf verschiedenen Frequenzen arbeitet. Typischerweise für IoT-Anwendungen mit geringem Stromverbrauch und großer Reichweite verwendet.
Connettività
Connettività
LoRaWAN
Long Range Wide Area Network, ein drahtloses Protokoll für Low-Power-Geräte in weiträumigen Netzwerken, ideal für das IoT.
Specifica LoRaWAN
1.0.3
Classe dispositivo
A
Klasse A-Geräte ermöglichen bidirektionale Kommunikation zwischen dem Gerät und dem Netzwerk. Nach jeder Uplink-Übertragung des Geräts sind zwei kurze Downlink-Empfangsfenster geöffnet. Diese Geräte haben die niedrigste Energieeffizienz und sind für Anwendungen geeignet, die keine festgelegten Empfangszeitpunkte erfordern. Beispielsweise könnte ein IoT-Sensor, der sporadisch Temperaturdaten an eine Cloud sendet, ein Klasse A-Gerät sein.
Frequenze
EU868
LoRaWAN-Frequenzband für Europa (868 MHz). Verwendet in Ländern wie Deutschland, Frankreich, Großbritannien und den meisten anderen europäischen Ländern.
Alimentazione
Alimentazione
Batterie
,
Solarstrom
Pile incluse
Ja
Numero di pile
1
Tipo di pila
Li-Ion
Pila sostituibile
no
Meccanica/design
Peso del prodotto (g)
420
Larghezza (mm)
125
Lunghezza (mm)
195
Altezza (mm)
55
Codice IP / protezione
IP66
Staubdicht. Schutz gegen starkes Strahlwasser und bei Überflutung. Ein IoT-Sicherheitskamera im Freien könnte diesen Schutz haben.
Intervallo di temperatura
-40 °C bis 85 °C
Informazioni commerciali
Paese d’origine
Cina
Altre caratteristiche
Sensori
umidità del suolo
,
temperatura del suolo
,
conducibilità elettrica
Luogo d’impiego
interno ed esterno
Server di rete
ChirpStack
,
Swisscom LPN
,
TTN