The WisGate Edge Prime RAK7240CV2 is our outdoor gateway — and what separates it from an indoor device is not the housing but the location it allows. A gateway on a roof or a mast sees further than one in a basement, and with LoRaWAN range comes almost entirely from a clear line of sight. It receives on eight channels with the newer SX1303 core, brings a network server along and reaches the internet by Ethernet, WiFi or mobile. The aluminium housing is sealed to IP65, the PoE injector is included, and it is managed remotely. The LoRa antenna is ordered separately.
- IP65aluminium housing for outdoors
- 8 channelsSemtech SX1303
- LTE · WiFi · LANthree routes to the internet
- PoEinjector included
What sets the Edge Prime apart
- It is allowed where the range is made: at 868 MHz, every metre of height and every obstacle removed counts for more than any setting on the device. A gateway that may go on a mast or a roof opens up a multiple of the area of an indoor device — and that is exactly what the sealed housing is for.
- Network server already on board: you can register sensors directly on the gateway and collect the data over MQTT, without an external platform and without a subscription. For one site that is often entirely enough; anyone moving later to ChirpStack or The Things Stack simply switches.
- Three routes outwards: Ethernet, WiFi and mobile. The LTE variant is the real reason for an outdoor gateway at remote sites — substation, treatment plant, field, construction site. There is no network socket there, but there is mobile coverage.
- Losing nothing when the server drops out: in packet forwarder mode the gateway buffers received frames for as long as the network server is unreachable. For an installation whose measurement series must be unbroken, that is the difference between usable and useless data.
- It reports its own power failure: the dying gasp function sends a message on the last remaining energy before the device goes down. Instead of a silent hole in the data you get the information that it was the supply and not the radio network — on a device on a roof that saves the first inspection trip.
- Power over the network cable: the PoE injector is included. On a mast that is decisive, because only one cable has to be run up instead of two. Alternatively the device takes 12 V DC.
- Remotely manageable: configuration, firmware and monitoring run centrally through WisDM. For devices you can only reach with a ladder, that is not a convenience but a precondition.
- Node whitelisting: the gateway can filter frames by device address and forwards only what belongs to your network. In densely used areas that noticeably relieves the backhaul.
Where it is used
- Coverage for a municipality or a site: one gateway mounted high replaces several indoor devices and comes out cheaper overall than trying to cover buildings one by one.
- Remote sites without a network: pumping station, substation, treatment basin, alpine pasture — connected over mobile, powered over PoE.
- Agriculture and forestry: wide areas, few obstacles — the constellation in which LoRaWAN actually shows its range.
- Construction sites and temporary installations: rugged enough for dust and weather, operational immediately over LTE, removable and reusable when the project ends.
- Industrial estates: covering several halls from one elevated position instead of running a device in each hall.
- Closing gaps in public networks: where Swisscom or The Things Network do not reach, a gateway of your own fills exactly that area.
- Redundancy for existing networks: a second gateway with a different backhaul — one over fibre, one over LTE — keeps the network available if one route fails.
That settles the selection. What follows is the depth for planning and installation.
Why mounting height decides almost everything
In LoRaWAN on the 868 MHz band, transmit power is capped by law, and nothing on the gateway changes that. What determines range is therefore not the device but the line of sight. Every obstacle in the first Fresnel zone — roof edge, tree, neighbouring building — costs more than any antenna choice can win back. A gateway ten metres higher can multiply the covered area, while an antenna with three decibels more gain changes it only slightly.
From this follows a rule for antenna choice that runs against intuition: more gain is not better, it is different. A high-gain antenna concentrates more flatly — it reaches further across a plane but blinds downwards. On a tall mast above hilly ground you therefore lose exactly those sensors in the valley below. For flat terrain the 8 dBi antenna is right; for a gateway above varied ground or in the middle of a settlement, 3 dBi is the better choice. This assessment comes from practical application and is to be understood as a selection aid, not as a guaranteed range.
What a built-in network server can do — and where it stops
The gateway can manage the sensors itself: register them, decrypt them, pass the data on over MQTT. For a single site that is the shortest route to running data. The limit shows as soon as a second gateway is added. If both receive the same sensor packet — which is normal and desirable — a shared server would have to discard the duplicates. With one server per gateway that does not work cleanly. So as soon as you cover more than one site or plan overlap, you sensibly move to a central network server and run the gateways purely as receivers in packet forwarder mode.
In practice: the built-in server is the ideal start and stays so for single sites. It is not the goal for a growing network. Switching over is a setting, not a rebuild.
Technical data
The general product data — protection rating, housing, weight, connections, manufacturer part number and origin — is in the detail table further down this page.
| LoRaWAN | |
|---|---|
| Channels | 8, Semtech SX1303 concentrator |
| LoRaWAN version | 1.0.3; 1.0.4 announced for the built-in server |
| Operating modes | built-in network server, Basic Station, packet forwarder |
| Buffering | LoRa frames are stored in packet forwarder mode if the network server fails |
| Filtering | frame filtering by device address (node whitelisting) |
| Timestamping | fine timestamping optional |
| Connectivity | |
| Ethernet | with PoE, injector included |
| WiFi | 2.4 GHz, external antenna |
| Mobile | 4G LTE, two external antennas, nano SIM (4FF) |
| GPS | external antenna included |
| MQTT | v3.1 with TLS, compatible with ChirpStack among others |
| Operation | |
| Power supply | PoE or 12 V DC |
| Failure reporting | dying gasp — message on loss of supply voltage |
| Software | WisGateOS 2 with extensions, remote management via WisDM |
| LoRa antenna connector | N-type, antenna not included |
Scope of delivery
- 1 × WisGate Edge Prime RAK7240CV2, 8 channels with LTE module
- 2 × LTE antenna
- 1 × GPS antenna
- 1 × WiFi antenna 2.4 GHz
- 1 × PoE injector
- 1 × mounting kit
- 1 × manual
- No LoRa antenna — that is ordered separately, see below
Matching accessories
- LoRa antenna with an N connector — mandatory: for gateways in settlements or above varied ground, the 3 dBi fibreglass antenna. For flat, open terrain the 5 dBi version or, if it has to reach as far as possible across a plane, the 8 dBi antenna at 1.3 m length.
- Surge arrester — with every outdoor antenna: the RAK N-type surge arrester goes between antenna and gateway. In addition, an RJ45 surge arrester belongs in the network line, otherwise the disturbance simply takes the other route into the building.
- Antenna cable and bracket: if the antenna sits away from the gateway, a 3 m antenna feeder line is needed. For mounting on a mast or wall there is the L-type mounting kit.
- If an indoor device will do after all: the RAK7268CV2 WisGate Edge Lite 2+ does the same on eight channels for considerably less — provided the device stands protected.
Installation and commissioning
The housing is sealed to IP65 against dust and jets of water, and the mounting kit is included. Two things decide the service life of the installation: the sealing of the antenna connection and the earthing. The N connection belongs wrapped in self-amalgamating tape — water ingress in the connector is the most common reason range declines insidiously over months. The earthing runs from the mast and from the surge arrester to the building’s equipotential bonding by the shortest route.
Check the radio link while you are still on the ladder. Visiting a gateway on a roof a second time costs more than the whole commissioning — and only up there does it show whether the antenna position works. For initial setup the device opens its own interface; configuration then runs through WisGateOS 2 in a browser.
Help with sizing
The datasheet and instructions are under the Documents tab at the top of this page. Unsure which antenna suits your terrain, how many gateways cover an area, or how the lightning protection is built? Tell us what you want to cover — the antenna question is gladly settled in conversation. And if it turns into a project — radio planning, pre-configuration in quantity or commissioning — we will gladly put together a quote.


Reviews
There are no reviews yet.